The Prism comes in a HUGE variety of sizes, ranging from a 20ft oval/rectangle or circular pool all the way down to a 10ft circular pool. The Intex Prism features a bolt-together assembly process that doesn’t require any tools and is staggeringly simple. Simply snap in some T-joints with heavy-duty plastic leg caps, install the pool filter, and you are in business.
I spent the first hours that the kids were in the pool, yelling at them not to bump into the pool walls or create too many waves; I was sure it was going to explode and wash them out into the yard. Although it may seem intimidating, if you think about what kind of intex purespa time you have to dedicate to a pool and buy accordingly, you will find the best pool for you. Nothing can give you the chills like a dip in the pool on a cold day in New England. But with AquaComfort’s state-of-the-art heating systems, you can enjoy your pool…
The flat surface we found in our yard was pretty far from the side of our house, but we were able to connect the pool pump to a power source via an extension cord. As for water, we had to run a hose from a spigot on a second-story patio down to the pool. It took between six and eight hours to fill the pool to the fill line, which is about 90 percent of the 1,718-gallon capacity.
Depending on how well your helper is sealing the opening with their hand this should stop most or all of the water from draining out. Install the new vent into the top of the bulkhead and the new valve. Make sure that the new valve is closed because you’ll want it to stop the water as soon as you get the new bulkhead installed.
If you’re planning to purchase an above-ground pool in time for summer, then the following sections are for you. When you order Intex equipment separately you may find your pool has the 1.25 inch hose connections and your new pump and filter have 1.5 inch hose connections. They do sell adapters that will allow you to connect the two together. Consider the size of Intex pool that will fit your backyard, the accessories you will need to keep it ready for swimming, and the shape of the pool you want.
Grab the new bulkhead and push it through from inside the pool. This should stop a significant amount of the water draining out, but there will still be some leaking out around the new bulkhead. Take the rubber gasket off of the new bulkhead and hold it in place around the existing return, then use a sharpie to trace around the inside of the gasket. Put the gasket back on the threaded part of the new bulkhead. Turn off the pump and make sure the suction ports are closed off, otherwise when you disconnect the tube from the return water will flow through the pump and drain from the pool. The next day it will turn on at the same time you started it and run for the set number of hours.