Remove the wheels from the carrier, then place the Shyft DualRide on the vehicle seat with the harness facing the rear of the vehicle. Thread the vehicle seat belt through the belt guides, buckle the seat belt, then route the shoulder portion of the belt around the back of the seat. If the retractor has not engaged by this point, pull the shoulder evenflo stroller wagon portion of the seat belt all the way out until it clicks, then let it retract back into the vehicle. Press down on the carrier to remove more slack from the belt, then check your work by giving the seat a firm handshake at the belt path. Evenflo’s most expensive infant car seat, the SafeMax has been side impact tested and rollover tested.
This video will demonstrate how to remove an Evenflo convertible car seat cover and put it back on. This video will demonstrate how to remove your Evenflo convertible car seat cover, and give you tips on how to clean your car seat. All of the Evenflo convertible car seats, minus the Symphony line, expire 6 years after their manufacture date. The Symphony line of car seats expires 8 years after their manufacture date because they’re all-in-one car seats with an extended use feature.
The main portion of the harness covers are referred to as “harness strap pads” and these have a grippy material sewn into the underside of the pads. I flipped it over to photograph the grippy material but I want to be clear that this is the backside of the harness strap pad which will be making contact with your child’s clothing. Pull the seat cover around the shell of the car seat and attach it to the plastic clips.
The seat is lightweight yet sturdy, and it is easy to keep clean. However, I would like to see some different options for anchoring the seat that would make installation easier and close to the same procedure for various types of vehicles. The seat is easier to install in face forward position and easier to place child in and secure the straps with less effort.
Some latch straps have a little loop sewn into the loose tail end that you can slip your index finger into and pull, but this strap didn’t have that option. Therefore, it took a little more effort for me to tighten the latch strap enough to yield a solid installation after the LockStrong bar was shut and locked. Once again, make sure you reference the visual indicator on the inside of the base to confirm that it has turned from red to fully green – indicating that the LockStrong bar is securely locked. Read on to learn how to put your car seat back together after removing the seat cover. If you need some more guidance, this short video will show you to install your Evenflo convertible car seat in the forward-facing position.